Posted by Bob Kerr on December 31, 2007 at 06:32:11 from (205.188.116.73):
In Reply to: Water posted by Kristof on December 31, 2007 at 03:28:37:
Anytime I put a part back on like a head or manifold I use a big mill "bass -tard" file (yes misspelled because of the potty mouth filter!) and run it across the surface in one direction and count the strokes. I then turn it around and do it the opposite direction the same amount of strokes and I hold it at about a 45 deg angle. Keep even pressure on it by using your fingers on the file surface and not on the ends of the file. Boy does it show high and low spots! Usually the worst places are where bolts or studs go into a block. The pull from the torqueing will pull the iron up eventually and make a hump around the hole. you have to pull the studs out to do it. Once in a while I will find a place where the original machining wasn"t so great. like if the machining groves are too deep or uneven. The humps around the studs will not let the head torque right and the rest of the gasket surface won"t reach torque (crush)spec. It is worth a shot to try it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Picking Corn - by Rick Nikolich. It was the day before Christmas shutdown at work and I asked our lead engineering expert Scott Andrzejewski what he was going to do over the holidays. He said that he had some corn that he still needed to pick with an antique one-row New Idea corn picker. Scott has a nice farm about an hour north of Lansing in St. Johns, MI. He wanted to get the rest of his corn in by the next day (Christmas Eve). We had about an inch of new snow on the ground and single digit temperatures. So in the bac
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
