Posted by Andy Martin on December 31, 2007 at 06:08:35 from (63.99.111.177):
In Reply to: Re: Water posted by Kristof on December 31, 2007 at 05:42:30:
Scratches won't be your problem. Sealers like paint might help but are not necessary. The head gasket will deform to match the surface. You have some other problem.
How good was the shop that milled the head? They may have screwed it up. You should check it with a flat edge, only because you are having a persistent problem. A machinist's straight edge is good but you should be able to detect light under a carpenter's framing square if the square is pretty straight.
Check the bolts carefully and see if the threads look like they are damaged at the bottom from bottoming out. If your head was milled quite a bit it will be thinner, causing the bolts to go deeper in their holes. They may be hitting rusted up threads. This can be fixed by grinding off the ends of the bolts or by adding washers (trimmed to fit).
Did you start the engine and get it good and hot, then retorque the head?
Did you check your torque wrench? I have a broken one I loan out. It seems to work OK but consistently reads low. It was OK when I first loaned it out, so I keep it for a loaner.
I've never had a warped block so that is what I would check last.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.