Posted by Hugh MacKay on December 29, 2007 at 04:07:05 from (216.208.58.165):
In Reply to: Re: bristish mta posted by Mike Farmer on December 29, 2007 at 03:24:02:
Mike: Do you have any good rear photos showing the factory 3 point hitch as used on Super BMD and B-450. I've seen many photos of BM, BMD, Super BMD and B-450 over the years, but never one that high lighted the 3 point hitch. I realize 3 point was not standard or optional on the early models.
Most of my info on these came from a Yorkshire man that imigrated to Canada. During the first 3 years, I had great trouble understanding his Yorkshire English and by that time we had covered the British Farmalls. I had always assumed the 3 point hitches he used as a farmer in England were his own fabrication. It wasn't until I came to YT, I learned these were factory 3 point hitches. Were they a draft controlled hitch? If so, was it top link or lower link sencing? When did these hitches become a reality?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.