Hello Greg, I wasn't going to respond to this, but figured you would like to have your saw cut correctly. Don't want to rain on anyones parade, but it is NOT that critical that the length of the chippers be the same on both sides of your chain, the cutting edge "angle" of the chippers MUST be the same on the left and right side of your chain.
I've put arrows to show that these chippers are shorter than the ones on the opposite side on this chain and it cuts straight. But you will notice the angle of the chippers are the same on both sides of the chain. I sharpen my chain at 20* also I use nothing but Oregon Chipper chain. Most smaller saws use either 30* or 35* on the cutting edge angle on the chippers.
If you don't have the experience on sharpening your chain, here is a tool that clamps onto your bar. It allows you to adjust the cutting angle and the pitch of the chippers. Sure beats the cost of buying a new chain everytime you hit a rock or foundation..LOL I found this in a box of junk I bought a auction. If you were closer I would give it to you..
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
