Posted by Matt Weltz on November 26, 2007 at 18:40:09 from (12.216.122.181):
Hey guys. Still trying to figure out the live hydraulics on my SH. Have the main line to the engine driven pump coming from the bottom of the belley pump housing and the pressure return line going back to the top of my 2-way valve. Then have 2 lines going to the rear for power up and down. Have the valve mounted directly on top of filler pipe coming out of housing for oil return. Trouble is that with a short nipple the valve hits and binds the starter switch. If I use the next taller nipple, the pressure line to the valve hits the bottom of the gas tank. I don't want any vibrations to rub a hole in the gas tank. However, I am afraid if I use an elbow and move the valve off to the side I will loose rigidity. Valve is not the IH christmas tree style. Anybody else have this trouble? Pictures would be great!!! Sorry for the long post but thanks for your help!!!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.