Posted by Jimmy Bruce on November 14, 2007 at 09:08:51 from (150.199.110.130):
A neighbor has a Super M that he only uses to rake hay with. We split the tractor in half and the clutch fell apart in three pieces. The rivets had sheared off. Everything else looked fine, i.e. throw-out bearing and pressure plate. When I installed the new clutch, same thinkness and style I noticed that when I tightened the pressure plate that the fingers moved from protruding out about an inch to being flush with the pressure plate face. I went ahead and installed the clutch and put the tractor back together. I pressed in the clutch pedal but the transmission would not disengage. I could see the throw-out bearing moving through the grease access hole but it wasn"t quite going up far enough to engage the fingers on the pressure plate. Is this the wrong clutch, it"s the same size and thickness as the one that was in it before, but is that why it tore out the center of the other clutch? I don"t know if the clutch had been changed before and he was just living on borrowed time but I know he has been raking with it for a few years now.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.