Bob, I stopped by to see Ron today (because I realized that your tractor is the perfect test case for the ongoing head discussion with Hugh, and wanted to check it over and get some pictures). Anyway, helped him split your tractor again. He had everything ready to go, pretty much just set the jacks, unbolt it and wheel the front off.
For the short version... I think the problem is the fingers on the new pressure plate were not set properly from the factory and never fully releasing the clutch. We checked the clutch disc, it was facing the right way; measured the flywheel depth, it was within ~0.010 of an original (they turned the clutch face as well as the mounting flange to keep the spec); but the release fingers were ~0.350 out and were not consistant, saw 0.150 difference between them.
I think his feeling is that the plate is defective and he wants to check the options for returning it. I know there are two schools of thought there and I have had to re-adjust the fingers on a new one in the past, but he is leaning towards, "it is a factory setting that should be correct when you pay this much for it". He has a point as: 1- the flywheel is at factory specs so there is no reason to re-adjust them; 2- the fingers are not even consistant between themselves; and 3- the adjusting bolts and lock nuts were glued at the factory. Ron is a great asset to us down here in VA, I have learned alot from him. He is an honest, hard worker and he will get it straightened out for you.
Just a quick note to say don't worry, your tractor will live again! :) Stan(VA).
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
