Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Farmall & IHC Tractors Discussion Board

Re: 484 Fuel Filter and Bowl Assembly


[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]

Posted by Fromjb2 on October 30, 2007 at 20:08:04 from (99.241.179.24):

In Reply to: 484 Fuel Filter and Bowl Assembly posted by Jay Shepherd on October 30, 2007 at 17:02:41:

Hi Jay, there are two different types of fuel filters for that model. Look at CaseIH parts site as below:
Just select "SEARCH for PARTS" link from the bottom of this page -

http://www.caseih.com/parts/parts.aspx?navid=123&RL=ENNA&partid=481&typeid=157

Then search for your model number on the page that opens.

Fuel filters are under POWER page 12-34 and 35.

Re bleeding the fuel system, there is a bleed screw on top of the fuel filter assembly (Item #12) on parts page. Open that screw a few turns and let fuel flow until there are no air bubbles coming out the bleed screw. Then close bleed screw. Put OFF/START/RUN control lever to START position and crank engine. DON'T crank engine for more than 60 seconds at a time to prevent over heating starter motor. If engine does not start within two 60 second cranking attempts then you will have to loosen an injector line at the rear of the Diesel injection pump and then crank engine again. BECAREFULL when you loosen the injector line because this is Diesel fuel under 3200 PSI and can cause serious injury.


Another thing that helps is to put small amount (10 to 15lbs) of air pressure in the fuel tank.

Good Luck
JimB


Replies:




Add a Reply

:
:
:

:

:

:

:

:

:

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity! ... [Read Article]

Latest Ad: Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy