Posted by Allan Lance on October 26, 2007 at 18:57:25 from (66.79.231.216):
Hey guys I have rebuilt my W6 carb and have a few questions. I took it all apart and let it sit for 2 days in carb cleaner which did a really good job of cleaning it up but at the same time I see it kinda softened the rubber that the main adjusting screw fits into. I'm wondering should I just screw it in tighter or can this rubber insert be replaced? I'd hate to put it all back together and then have to tear it all apart again cuz it leaks or something. Also where the governor linkage connects to the housing on the tractor motor I'm noticing some front to back play, is this normal or can I tighten it up with some JB weld? I'm in the process of rebuilding the tractor so I'm sure more questions will follow, thanks for all the input in advance.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
