Posted by Rootsy on October 25, 2007 at 05:03:37 from (24.176.33.123):
In Reply to: Farmall M paint posted by Zach Bouchard on October 24, 2007 at 15:54:27:
Zach Bouchard said: (quoted from post at 15:54:27 10/24/07) Is the Tisco Red and Silver paint the right color? One guy on here said some colors have an orange tint to them. I would like to know if the Tisco paint is like the original. How much paint will I need to paint a Farmall M?
If you are going to use an 8:1:1 enamel you'll need roughly a gallon and a half to two gallons depending upon how many coats you need to apply. A gallon of primer mixed 8:1 should get the job done also.
IF you are going to shoot a PPG Acrylic Urethane mixed 4:2:1 you'll need about a gallon and a quart and you'll have a good portion of the quart left over after applying the 2nd coat. 1 gallon of DPLF epoxy primer mixed 2:1 req'd.
I've painted em both ways (depends on my intended use and customers desires) and it is better to have too much than not enough....
The PPG 2150 equivalent (71310) does have an orange tint as you can see by my 1950 M. It isn't that noticable in the photo but in bright sunlight you can see it... gray primer was used beneath.
The 350 I just finished is CIH 2150 enamel.... it's pretty red... no noticable orange like my M when in the sunlight. mustard yellow primer beneath
Also be aware that the primer color you apply can slightly modify the tint of the paint.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
