Posted by ScottyHOMEy on October 07, 2007 at 13:53:09 from (71.241.214.74):
I didn't want to hijack his thread, but your response to his question on his gen piqued my interest. Between getting one old tractor running in good order again, and getting the workhorse squared away before winter, I've been dealing with generator/charging issues.
Can you correct me where I'm misunderstanding.
Assuming a three-stud cut-out relay with a four-position switch on the ammeter panel. Is the resistor at the switch eating amperage or voltage?
Going the other way (I ask because I have one of each) a four-stud regulator and a three position switch, I assume the reistance to a charge is the second coil in the regulator???
And if I read you right is the following a good way to look at it?? . . . realizing that the generator loses efficiency as it heats up, does it put out a constant voltage at any temp, implying that the temp affects only amps or wattage, given vA=W?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
