Posted by jbf on September 24, 2007 at 20:14:05 from (69.40.210.166):
Can the H and M govenors be switched? I just bought a govenor of ebay supposedly for an H. The carb control rod was about 3/4 of an inch longer than mine and the neck ontop the gov was taller along with the control rod from the govenor. The gears had 16 teeth on mine and 17 teeth from the one I bought. I changed the gears and shafts. The tractor sounds good from idle to high idle, but you have to hold the control rod by hand or it will run up to around 2200 rpm. At an idle I can pull up on the rod and it will rev up but will not go back down unless I push it down. I have tried all the adjustments according to the book. At full throttle, holding the carb control rod open the rod from the govenor dosn't have enough threads to screw the adjust block down enough to insert the pin freely. Any suggestions are appreciated.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.