Posted by Hugh MacKay on September 16, 2007 at 03:03:03 from (216.208.58.152):
In Reply to: 300 loader on M? posted by bnowen on September 15, 2007 at 20:58:45:
Billy: Another item I forgot to mention, my dad had a 33A loader on our 300 before I installed the Wagner. 33A was considered the Farmall loader and the U-34 was considered the utility loader. I forget the exact specs, however the U-34 had a considerably higher lift capacity than the 33A. A neighbor had a U-34 on his 350 Utility. The U-34 has a lot more steel in it than the 33A, and yes, what we saw way back in the 50s the U-34 would lift more than the 33A. That neighbor's son still has the 350 with U-34 loader. My 33A loader went to the scrap yard in mid 1960s. The Wagner would perform with the U-34.
I never could figure why manufacturers figured utility tractors could handle a higher capacity loader than a row crop, however they all did it up until the mid 70s. Personally I though the longer wheel base row crop would handle the extra weight best.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.