According to the Aftermarket engine catalog I am looking at, The T6 used the Farmall M/ McCormick Deering W6 C-248 engine. The Early T6 Series 61 used the C-263 from the Super M, Super MTA, 400, Super W6, Super W6-TA and W-400. The Late T6 Series 61 used the C-281 from the 450. The TD-6 and TD-6A used the D-248, the TD-6 Series 61 used the D-263 and later the D-281 and lastly, the TD-6 Series 61 used the D-282 from the 560, 660, 656, and 706.
I would imagine that you have either the D-248 or the D-263. They are readily available from the wheel tractors, and most of the parts are still available as well. If not operated properly, there was the distinct possibility of cracking the complex head casting (which used 3 valves per cylinder; 1 intake, 1 exhaust, and 1 starting valve to uncover the sparkplug) The heads, from what I've heard are NOT readily available. They were excellent on fuel, though.
Did the starter make any noise like it was engaging something when you pressed the button? It is possible the starter locked in the flywheel teeth, in which case, you simply unbolt it and put it back in. More than likely though, if there was a large bang when it was parked, something catastrophic occurred in the motor and that is the problem. Next would be to try a pry bar on the ring gear or a handcrank or pipewrench on the crankshaft. You may want to consider removing the pan and/or the valve cover and see what you've got. If something is jamming it up, trying to turn it over will only wreck more usable parts. Putting some hydraulic/ automatic transmission fluid or penetrating oil in the cylinders couldn't hurt either. The starting valves must be open in order for it to reach the rings through the spark plug holes, though.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
