Posted by Chris NW Ind on September 03, 2007 at 10:47:14 from (64.136.26.226):
In Reply to: shaft bearing posted by farm it all on September 03, 2007 at 01:50:53:
Bearing is a light press fit on the output shaft and just fits inside the input shaft. I knocked it off with a hammer and punch and used the bolt and cap to pull it back on the shaft. As far as I can tell, the rollers will not fall out unless the bearing is damaged so I see no reason for a rubber band.
Do you have it completely apart yet?
Are you replacing the input shaft ball bearings and seals also? Since you have it apart as far as you do, I'd do that also. For myself, in addition to the above, I replaced the countershaft seal and belly pump seal and the 4th/5th slider. All the seals were leaking, but no more. Pretty easy job actually.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.