Farmall & IHC Tractors Discussion Board |
Re: operate two way cylinder with Lift all pump
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by john d on August 01, 2007 at 17:26:43 from (69.130.180.196):
In Reply to: operate two way cylinder with Lift all pump posted by Brad in WI on August 01, 2007 at 16:41:49:
Connect a hose from the front port on the left side of the tractor, or the only port on the right side of the tractor to the end of the cylinder that makes your equipment lift. Remove the hose from the other end of the cylinder and install a "breather" that will let air enter that end of the cylinder. These are commonly available from any hydraulics supply place. The hydraulic pressure will lift the equipment, and gravity will lower it when you push the hydraulic control rod all the way forward. If the tractor cannot lift the load, a larger diameter cylinder will help.
Replies:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|