Farmall & IHC Tractors Discussion Board |
966 Repair Didn't Work
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Allan In NE on August 01, 2007 at 05:24:18 from (148.78.243.25):
Well, that was a wasted effort! :>( Hi-Lo shift linkage on the 966 sheared the roll pin, so I replaced it with a 1/4" bolt and double nutted. Had a heck of a time "reaching" the detent; really had to play with it to get the old sow in gear; both directions. Fought it long enough to finish the baling and the summer fallow ground then I tore the tractor back down to parade rest. Went into town, searched high and low and finally found a 7mm bolt and the proper drill bit to ream 'er out and "oversize" it. Was all set to start drilling it out. But first, and for some reason just on a "whim", I then tried a common, everyday 1/4" roll pin. Had to beat it in with a hammer and stout punch. Darned tractor "acts" normal now and shifts just fine. Hope it lasts. :>( Pictures are the "no-go" repair. Allan
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|