Farmall & IHC Tractors Discussion Board |
Re: IH 340 utility hydraulics
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Al L. in Wisc. on July 26, 2007 at 10:23:25 from (209.103.222.221):
In Reply to: IH 340 utility hydraulics posted by Doug Warner on July 24, 2007 at 18:14:37:
Doug, I had an International 240 that had such a hot hydraulic pump it immediately blistered the "hide" on the mechanics hand when he touched it. Problem was diagnosed as a plugged screen in one of the hydraulic valves (as JJ has setting on the "unused" kitchen counter top). Yup, the heat is bad as it can ruin the pump. Possible one of the small pins is broke? When the pump is "used" by operating a lever, pressure flows through the system and thus no straining same. You won"t want to run it for long, but if you need to move the tractor, hold one of the levers allowing the system to operate and it shouldn"t over heat, note I said shouldn"t. Good luck and keep us posted.
Replies:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|