Farmall & IHC Tractors Discussion Board |
Re: IH 340 utility hydraulics
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Larry in Mo on July 24, 2007 at 20:51:50 from (75.105.155.251):
In Reply to: IH 340 utility hydraulics posted by Doug Warner on July 24, 2007 at 18:14:37:
Doug; after re-reading your 1st post the thing I got to thinking about was your comment about "valves by the shifter".If what your talking about is like the 2nd picture JJ posted, those are the actual valve bodies the controll levers are hooked to that are shown in the 1st pic JJ posted. The shaft that extendes from the valve body controlls the flow for either single or double action cyls. Turn ccw, or up for double action(pressure both ways) or cw for single action. Now if you have hyd lines going to both ends of all hyd cyls they are double action, and the control valve pin should be set accordingly. Your loader should be getting its hyd power from the two ports on each side of the tractor, usually with quick disconnects on them. If this isnt the case,someone has rigged another system. If you want, email me your phone number and i'll give you a call. lee123@dishmail.net . LE
Replies:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|