Farmall & IHC Tractors Discussion Board |
Re: 560 rim/wheel clamp problem
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Armand Tatro on July 19, 2007 at 17:16:10 from (67.176.252.97):
In Reply to: 560 rim/wheel clamp problem posted by Clefus on July 17, 2007 at 18:59:07:
Relocate clamps(wedges) to where they belong and see if they will tighten up; mabey use new bolts before buying new wedges(clamps): use long breaker-bar if needed. To my knowledge all clamps are the same. If you have to move to the next bevel-ring you may have to move cast rim on axel to get propel wheel spacing for plowing or whatever. Retighten all nuts and/or bolts after 4 hours of use and a couple more times for the first week, even on the good wheel. Also when you tighten the clamps after moving them be sure wheel runs true(straight) as you tighten them otherwise wheel may wobble. Also retighen as soon as you hear clunking noise in future. Armand
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|