Farmall & IHC Tractors Discussion Board |
Re: Tire sizes for a 2404 or 404
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by HughB on July 17, 2007 at 05:10:41 from (69.19.14.23):
In Reply to: Re: Tire sizes for a 2404 or 404 posted by georgeky on July 16, 2007 at 16:02:57:
Thanks guys for the input. It is an International 2404. It came with duals when I got it. They make it to wide for what I use it for. My shop manual shows the same gears for the 404 and the 2404. The metal wheels to fit that tractor may be hard to find,note the wheels are a tight fit over the hub. Turf tires won't work as I use it to pull a disc and turning plow on a small truck garden. Let me also check with the Case IH dealer when I get over that way (Moulton Alabama) 100 miles round trip. Thanks for all your input. HughB
Replies:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|