Farmall & IHC Tractors Discussion Board |
Wacky Idea?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Goose on July 15, 2007 at 16:18:59 from (199.184.119.22):
I recently converted my Allis D19 to a 12 volt GM internally regulated alternator. Out of necessity; the generator quit working, and I had several good GM alternators on the shelf. I'd like to do the same to my H so I could put some decent lights on it. But-the GM alternator is too big to fit under the hood where the original 6 volt generator sits. I noticed there is room to mount the alternator on the right rear of the engine in front of the gas tank. So, my idea is mount the alternator in a fixed position back there, then mount a bearing block with a 2 1/2 inch pulley in place of the generator and run a 1/2 inch drive shaft back to run the alternator. You'd need to put a couple of small u joints in the shaft, and you could direct drive the alternator by welding something onto the pulley nut that would connect to the shaft. My theory is, the tractors electrical system doesn't know where the alternator is as long as it's turning at the proper rpm, and it would all fit under the hood with nothing showing externally. Wacky or not?
Replies:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|