Farmall & IHC Tractors Discussion Board |
Re: B414 Engine Bearings
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Lee B414 on July 02, 2007 at 12:25:31 from (74.36.243.92):
In Reply to: Re: B414 Engine Bearings posted by El Toro on July 02, 2007 at 11:57:07:
Thanks for the info. I am trying to get by and not pull the engine. I don't want to get too much money into the engine - tractor is not worth the money needed to rebuild. The bearing do not have any size markings except for the IH part number so I was hoping someone could tell me the size based on the IH part number. My plan is to just replace the bearings with the origional size and hopfuly get me by. Thanks, Lee
Replies:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|