Farmall & IHC Tractors Discussion Board |
Re: A intermitant spark
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by El Toro on June 30, 2007 at 10:43:21 from (205.188.116.73):
In Reply to: A intermitant spark posted by HENRY E NC on June 30, 2007 at 07:54:43:
Are you sure you have those points nice and shiny? The gap set at .013"? If they are shiny and gapped at .013" I would replace the condenser and then see if there's fire. Pull the coil wire from the cap and hold within 1/8-1/4" of a good ground while some makes an attempt to start the tractor. I would disconnect the ground wire at the mag for now. I would replace the coil wire too, to make sure its not the problem. If there's fire now from the coil wire reconnect to it to the cap and check for fire at one of your plugs. If there's no fire you may have a weak coil or your magnets may have lost their magnetism. An easy way to rule out the magnets is to touch them with a flatblade screwdriver and see if they attract that screwdriver with some effort. The magnets are what creates your spark as they pass by the coil. Hal
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|