Farmall & IHC Tractors Discussion Board |
Re: Super MTA Hydraulics Operation
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Wardner on June 24, 2007 at 09:51:55 from (4.154.245.36):
In Reply to: Super MTA Hydraulics Operation posted by Smith1000 on June 24, 2007 at 08:53:58:
You have a series/parellel problem. Your two loads are in series and the oil will go to the load with the least resistance. My solutiion would to remove the Christmas tree valve (remote valve) and pipe your lift-all into a two (or three) spool open center valve bank. You could make a bracket so that it is near the steering wheel or mount it vertically on the battery box or right angle bracket bolted to rear frame cover. You now have independent control over the two loads as long as you only use one at a time. The lock for the lift-all is small tab of steel near the operating shaft that goes into the lift-all. Rotate it while the lever is pulled back to send fluid to the new valve bank.
Replies:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|