Farmall & IHC Tractors Discussion Board |
Re: Engine ID question
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hugh MacKay on February 10, 2007 at 14:53:15 from (209.226.247.128):
In Reply to: Engine ID question posted by Chris from Wa on February 10, 2007 at 12:23:35:
Chris: Does it have engine cubic inch cast letter and numbers near or behind oil filter. example C-123, C-135, etc. The letter Z indicates 1954. To my knowledge, all of the engines that will bolt up to a Super C are exactly same length. What makes you say this engine is shorter? You obviously have a reason. Could it be that someone has installed the wrong hood? A Super C water pump should bolt on over the lower engine water jacket port, and be driven by the main fan belt. On the older thermosyphon tractors fan belt went around crank and fan pullies only. Your fan belt should go around three pullies; crank, fan and water pump. Tell us more, and no jokes until after 10 pm .
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|