Farmall & IHC Tractors Discussion Board |
Re: Need some chain saw help.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hugh MacKay on February 10, 2007 at 13:53:21 from (209.226.106.182):
In Reply to: Need some chain saw help. posted by Paul Shuler on February 10, 2007 at 13:08:50:
Paul: I wasn't going to respond at first, as it sounded as though you were looking for a guy to put on the handle end. I keep my chain saw in a corner where by I never need touch the handles or operator controls. You must realize I'm looking at this, from the perspective of a 65 year old. Seriously, I think Chris has it nailed, chain just a wee bit too tight, bar pinched. Rambunctious guys trying to get it cleaned up in a hurry will do this. Ask yourself how often you got bar pinched from tree presure. The end of bar roller may also be a factor, but that should lubricate from oil going along bar, is your oiler putting out enough oil. Take the bar off, see if oil ports may be partially plugged. If you rev the saw up with end of bar pointed at clean snow or a board, it should put a slight oil stain on either. Not a lot, you should see traces of oil on the snow or board after 10 seconds. Another factor to check are you using chain saw chain oil and proper viscosity for season? That can have an effect, other type oils are a nono.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|