Farmall & IHC Tractors Discussion Board |
Re: Farmall A Exhuast Manifold torque spec
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by glennster on February 09, 2007 at 06:25:46 from (68.78.75.201):
In Reply to: Farmall A Exhuast Manifold torque spec posted by Chad from Michigan on February 09, 2007 at 06:11:33:
i dont know the torque spec, but i did put a manifold on my b. same 113 motor. it has a coarse thread stud that goes into the block, and fine thread on the manifold side. i got a little overzealous with the tightening and pulled one stud out of the block, had to heli coil it. id guess maybe 25-30 lbs. best bet is use a 3/8 drive short handled rachet, snug em up, warm up the engine and re-tighten em. dont kill em, just get em firm. the fine threads generate a lot of torque.
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|