Posted by f20inmi on April 12, 2009 at 19:34:06 from (75.167.203.133):
In Reply to: F-20 Rear main seal posted by Tiger Tex on April 12, 2009 at 18:45:51:
Get ready for a chore. The nut should come off with a set of plumbing pliers. You will need a heavy (and I mean heavy) duty puller to pull the flywheel off the shaft. It laughed at my harbor freight puller. The seal is a felt seal is straight forward swap. Rice Equip will have the seal. The big pain is putting it back together. You have to install a dowel at the same time that flywheel is slid back in place. It took 3 of us to re-install the flywheel. You will want to heat the flywheel on the bbq grill and then two of you will push the 100+ lb flywheel on the crankshaft. The third wheel will install the dowel at the same time you are pushing the flywheel on. Good luck.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.