Farmall & IHC Tractors Discussion Board |
Re: Taking apart the governor
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Tallperson on January 08, 2007 at 13:17:20 from (165.170.128.66):
In Reply to: Taking apart the governor posted by Guff on January 08, 2007 at 12:46:57:
Mine has done that a time or two also.... I have discovered that there is some moisture/condensation that has frozen and siezed up the governor linkage... So when the motor warms up it works ok. But unless you are using it really hard and get it really warm it will not drive out the moisture and when it cools down again it freezes again. I have stopped it from happening right now by using a heat lamp to warm up the governor before I start the tractor. I will pull it apart when the snow gets gone and I can stand to have the SM down for a bit, But right now i have been clearing my drive and around the barns nearly every other day... The snow is pretty deep here and more is on the way. Tallperson
Replies:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|