Farmall & IHC Tractors Discussion Board |
Taking apart the governor
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Guff on January 08, 2007 at 12:46:57 from (169.143.0.103):
Hi Guys, Got some feedback that moisture in my governor might be causing my 51 H to rev up to high RPM during a cold start (it did it again). I was lookin at it this weekend and have some questions: There is a pipe that comes off the left side of the carb into a gizmo that has a cap on top w / 2 screws and a piece of tubing coming out of it's top and running up into the front of the block. It sets on another gizmo with about 8 bolts going around a D shaped plate, which one is the governor? Second question, do I need to pick up a gasket before I pull it apart? Is it possible there is something worn out in there, even though it works fine once it warms up? Third question, can I open it up and spay some WD40 in there, and would that help my problem? Thanks Guff
Replies:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|