Farmall & IHC Tractors Discussion Board |
Re: Rust removal
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by the Unforgiven on December 26, 2006 at 08:02:37 from (4.228.228.1):
In Reply to: Rust removal posted by sattin on December 26, 2006 at 05:21:17:
It's the hot set-up if you don't like to break parts. I use several different tubs, from Tupperware for small parts to a fiberglass tank that will accomidate a six-cylinder engine. I did an Economy engine that had been buried, and I mean it was rusty, the nuts on the head bolts were nearly rusted off, the valve stems were rusted off even with the guides. It was in for three weeks and drawing all the amps I could put to it. When it came out, it was disassembled using a screwdriver, pliers, and a hammer and driver for the piston in less than 30 minutes with no broken parts! Did a Hopkins and Allen rifle that was rusted solid, when it came out, if not for the hammer spring being rusted in half, you could have dropped in a round and fired it. When you get the hang of it it really is amazing.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|