Farmall & IHC Tractors Discussion Board |
Re: Farmall A engines sleeves removal
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by ddg on December 22, 2006 at 12:29:47 from (152.163.100.65):
In Reply to: Farmall A engines sleeves removal posted by oldcar29 on December 22, 2006 at 06:40:45:
I couldn't knock mine out of my SA. I went to the hardware store and bought some continuosly threaded 5/8" rod & some nuts & washers. I had some 3/8" X 2" flat bar laying around & cut it up into lengths that would span the sleeves. I drilled a hole in the centers for the rod. I put the rod down the cylinder, and put on a plate, and a nut at the bottom end. On the top, I pulled the rod & plate up tight against the bottom of the sleeve, and put on a longer plate across the liner I was pulling. I laid a couple of nuts under each end, to bridge the top of the sleeve. I screwed another nut down on the plate, and tightened it down with a wrench. That will jack the sleeves up enough to break the seal, and it should lift out by hand after that.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|