Farmall & IHC Tractors Discussion Board |
Re: Need trailer hitch advice schooling
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Doc Larry on December 22, 2006 at 06:04:56 from (216.146.101.227):
In Reply to: Need trailer hitch advice schooling posted by Paul Shuler on December 21, 2006 at 22:26:06:
Paul, Sounds like you have a factory hitch. You want too much capacity, not too little. Get a 10000# hitch, get an equalizer, a 10000# slide tube, brakes on both axles, and balance your load to get a reasonable tongue weight when you load up. Most trailer sway is from having the weight too far forward or too far back on the trailer. I don't know what an H weighs but your trailer empty weight will be around 2000# or more. Larry
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|