Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Farmall & IHC Tractors Discussion Board

Re: best 100+hp tractor with 540 pto


[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]

Posted by John A. on December 14, 2006 at 12:17:56 from (63.233.102.32):

In Reply to: best 100+hp tractor with 540 pto posted by dx29 on December 14, 2006 at 06:27:16:

dx29, I am a Big Red IH guy from way back. I "Ditto" the others on a 966, 856, 826, A 966 will fill the bill on 100+ horses, Will turn a 15 ft batwing shredder quite nicely. At least mine can twist the gearboxes out of it. They are fairly econimical to run too. These tractors only real drawback is when you are in an idleing situations, ie... like very light loader work, @ 1500 rpm or so for long extented times the engine will go to "Slobbering" oil out of the exhaust. Nothing really hurt, just put a good load on it for 30 minutes to 1 hour and it will stop. Mine only does it after extented idleing time.
here in the last year or two I have had the oppertunity to run a JD 4230 it had good power for faarming, a 15 ft batwing annd the like. I cam recomend it too
My 966, bought used in 92 gave $6250 for it + $2000 for an IH 2350 loader. The only work I have have done to it, was Clutch, PP,throwout bearing, a rebuilt TA and some seal work 5 yr ago, cost $3200. + one set of rear tires, and 2 sets of front airplains tires. That is cost and work to date.
The 4230 was bought, painted, a Koyker 565 loader added, and delivered from Amarillo Texas for $15000. Have changes out the rear tires with new, and put airplanes on the front.
This tractor had a tranny problem when we got it. just hard sifting, and not stayinng in 5th. We sent to shop to correct this problem and add a 3rd remote outlet cost $3300. So that is cost and work to date on it. Both have their +s and -s , so either would work for you! Hope this helps.
Later,
John A.



Replies:




Add a Reply

:
:
: :

:

:

:

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and ... [Read Article]

Latest Ad: Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy