Farmall & IHC Tractors Discussion Board |
Re: Schwartz WF
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by IHC-Farmall on December 13, 2006 at 04:57:32 from (208.252.179.24):
In Reply to: Schwartz WF posted by GordoSD on December 12, 2006 at 19:17:02:
I dont think it will, i think where is bolts up that controls your steering is a smaller, One way to see if the back support is right is to measure from one side of the tractor to the other side (from one heavy bar to the other on the out side of the engine) do that with booth tractors, i think the 300 is 2 inches bigger, i know a person who didnt measure anything to see if it was going to work or not, where you bolt the 2 steering peices to gether he just put small bolts in there and for the back support they were close enough he just welded them on, I think i would just leave it, the narrow front back onto the other he also had to use small bolts. I guess you could do some meausing. Good Luck
Replies:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|