Farmall & IHC Tractors Discussion Board |
Re: Cub transmission question, pops out of reverse
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Roger46 on December 11, 2006 at 18:03:18 from (69.58.144.80):
In Reply to: Cub transmission question, pops out of reverse posted by tim in NC on December 11, 2006 at 09:44:53:
I just finished rebuilding a Cub transmission as part of my restoration process. Mine had a broken shifter fork. They are just made from stamped metal and seem quite fragile. If I remember correctly, there is only one ball that drops in and out of the detents for each side of the gear pattern, so it would seem that it may not be the ball unless there is crud in the detent in the reverse side. The forks are actually mounted on shafts on each side of the transmission. If you take off the top cover you should be able to see if the forks are OK. If it is a ball detent problem or a fork problem you will have to split the tractor as the shifter shafts come out of the front of the transmission. Roger
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|