Farmall & IHC Tractors Discussion Board |
Re: Need an internal gear for a 300 U hydraulic pu
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Jimer on December 10, 2006 at 10:01:21 from (198.174.213.51):
In Reply to: Need an internal gear for a 300 U hydraulic pump posted by SKK -Big Red Fan on December 09, 2006 at 18:17:03:
I have a 300u and just went and looked at a new pump (I thought I needed), just to be sure. There are only two gears, the drive gear and the driven gear. The drive gear is on a imput shaft that also drives the distributor The driven gear I believe does the pumping. I think you will need to take yours apart and see what you need as there are other parts also. Re: your crank question. Mine did not come with a crank, and I needed to turn #1 cylinder to top dead center to remove/install my hydraulic pump. I used 5/8" rod and a 5/16" pin on the end and I am able to turn the engine to get what I need (with the plugs out).
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|