|
Farmall & IHC Tractors Discussion Board |
Mr McNelly,,,, governors,,,
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by ChadS on December 07, 2006 at 10:03:39 from (66.228.96.135):
Chuck I tried returning your Email, but wont go thru!! So Ill post the info your looking for here,,,,, What your looking to do is speed up the mechanical funtion of the governor. If you got the spring with the little steel clip on one end, remove it, go to TSC and get you a spring,, the same length,,,, Yeah, even though it seems strong tensioned, but its still probably 50 years old, and they lose tension from heat. A stiffer spring is the best way to speed up reaction time,,,, then build on top of that,,,, Yes, when a sudden load is applied,,, the governor should respond,,, but it wont if the Hand lever is in idle,,, it has to be up just a tad so it will respond,, it wont go to WOT,, but will increase. Dads super M, has a M&W governor on it,,, and that thing is so sensitive, if it feels a sudden drop in rpm it will respond wildly!! But its not a real good high performance governor,,,, more for belt, and PTO work to keep the rpms steady,, the weights are so heavy,,,, they shut the carb down faster than a 2 weight, and will kill the engine quicker. Removing some material off the weights will also help increase responce time,,,, its up to you on how much to remove,, but I take as much as I can without damaging structure integrity. Lighter weights are better, heavy spring tension is best, that will wake up a governor real quick. Hope this helps,,,, need more info, ask away! Happy Holidays, talk to you soon. Chad
Replies:
- Re: Mr McNelly,,,, governors,,, Charles McNelly III 18:43:02 12/07/06
(0)
- Re: Mr McNelly,,,, governors,,, Charles McNelly III 18:19:53 12/07/06
(0)
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
