Farmall & IHC Tractors Discussion Board |
140 Front Weights
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Likes The Farm on December 01, 2006 at 06:52:39 from (206.107.117.6):
Planning to put front weights on 140. After finally finding them. Sometimes granddaddy would use them sometime not. Most time not. And I have never put them on and was to lttle to remember last time they were on. Am starting to use tractor more to disc now and think little more front weight would be nice. Weigh about 25 pds a piece. Tractor alaready has grill which about 25 pds and may only put the right side on. On the old weights looks like it takes a half ince carriage bolt. Wheel has four square holes which seem to mate to the holes in the weight. Am I right in thinking you put weight on outside of wheel hub. Thread carriage bolt through hub till it squares up in hub and then tighten? And would just putting the right side on be alright? Have run tractor with the weights but have never put them on. Thanks.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|