Farmall & IHC Tractors Discussion Board |
Re: Farmall A clutch fix
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by banjo on November 23, 2006 at 18:30:32 from (65.67.203.140):
In Reply to: Farmall A clutch fix posted by Randy Graf on November 23, 2006 at 18:17:06:
the bushing is the pilot bushing for the shaft. It is inside the end of the crankshaft. You can get the old one out by getting a socket that fits the inside gole and putting grease in the hole. Use a hammer and extension to jack it out. put grease in hole put socket and extension in hole ,hit with hammer. it will push the old bushing out. just keep adding grease till you have it out. The release bearing should be easy to replace also. it is pressed on to the shaft that slides when the clutch is pressed. you can probably drive the old one off and carefully drive the new one on in its place. Hopefully someone will have better instructions. Just trying to let you know it is not a hard task.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|