Farmall & IHC Tractors Discussion Board |
1466 Adjustable Front End
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by 61-4010 on November 21, 2006 at 19:30:31 from (198.203.175.175):
Hi everyone. Just took receipt of 1466 and I"m SOOOO excited. Looks like I have a little bit of work on her....but overall, she is a nice one. Have a question, though, regarding the front end. I noticed there is approximately 3/4 inch or more gap where the front pin that holds the axle and the axle itself. There are 3 or 4 large washers on the pin but still a good sized gap between the axle and where the axle is held on via the pin (hope this makes sense). I"m not familiar with the 1466 front end and not sure if this is normal or not. So if any of you have some pictures that you could take of your 1466 (or similar) front end, I"d love to have them for a reference point. Thanks!
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|