Farmall & IHC Tractors Discussion Board |
Int'l 966 Hydro Will Not Move
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Marvin on November 21, 2006 at 19:14:27 from (66.82.9.83):
When tractor is initially started--it will not move. If you run the throttle up to about 1600-1700 RPM's, and move hydro lever forward,the tractor will then take off. If you idle it back down, it will work perfectly fine. Reverse works perfectly fine. As long as you don't shut it off for more than 30 seconds. If you let it off for more than 30 seconds, you have to repeat this same procedure all over again: running the throttle up to 1600-1700 RPM's and moving the hydro lever forward -- it then will move again. You then can go forward or backwards at any RPM. -- Just can't turn it off and start again. Any help? I'll be grateful!
Replies:
Home
| Forums
Today's Featured Article -
Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|