|
Farmall & IHC Tractors Discussion Board |
Re: Touch control guage????? What is it???????
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hugh MacKay on November 18, 2006 at 01:54:12 from (216.208.58.132):
In Reply to: Touch control guage????? What is it??????? posted by Patrick Martin on November 17, 2006 at 20:58:21:
Patrick: Unless you have remote valve hydraulics and using hydra creeper drive, that gauge will probably never move from cold. It probably will record heat if one lets the hydraulic resovoir run low in oil, however by the time the gauge records hot in that senario, one has already cooked the pump. Over the years I've had 3 tractors with the gauge and 3 that never had the gauge from the factory. One of the tractors with the gauge was bought new and I've yet to see it move from the cold mark. Of the three offset tractors I still have, only my Super A had the hydraulic temperature gauge. I removed that 20 years ago without any adverse effect. My 130 and 140 never had the gauge. All three of those tractors have their original pumps, touch control has never been rebuilt and hydraulics still perform as new. Secret to running one of these tractors, is every time you check the engine oil level, also check the hydraulic oil level. These do not have a very large hydraulic oil resovoir, thus even a small leak can soon empty the system, and that is the single biggest reason for hydraulic rebuild.
Most of the Super A had the gauge, however not many of the 100, 130 and 140 ever had it unless buyer requested the option for his particulr hydraulic use. Personally I'd never replace a hydraulic temperature gauge on one of these. I suspect if you delve into the matter you'll find the gauge was always an option.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
