Farmall & IHC Tractors Discussion Board |
Gas start diesels
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Buddy Woodson on November 11, 2006 at 14:09:49 from (205.188.116.133):
Guys, I need your help on this one. My 450 diesel had a gas valve to stick in the open position and of coarse it missed on that cylinder on the diesel side. As you know the valves are recessed on both ends. I tried all the wonder sprays and finally had to remove the head and drive the valve out. After cleaning it on the wire brush wheel and cleaning the valve guide, it seems fine. Do any of you have any ideas on why it stuck. It is not warped. The tractor ran fine before this happend. I normally leave it on the diesel side when I'm not using it. It is quite a job to take the head off a diesel high crop working on a ladder. Thanks, Buddy
Replies:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|