Farmall & IHC Tractors Discussion Board |
A Farmall Rebuild
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Joe in Tennessee on November 02, 2006 at 14:02:55 from (207.162.166.103):
The new sleeve and piston kit ordered from this site for my A arrived today. The sleeves do fit and they install much easier than the old ones came out. But the new seal ring is a fat O ring. The old seal was square edged with a near square cross section. My old pistons are cast iron, flat top, and have 4 rings. The new ones are aluminum, flat top, and have 3 rings. The new ones have a V shaped notch on top but does not have any labeling that I can find. The old pistons do not have a notch. I assume the notch goes toward the front of the engine. Is this correct? Is there another purpose for the notch? If/when I do this again is there a source for new cast iron pistons instead of aluminum? Thanks.
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|