Farmall & IHC Tractors Discussion Board |
Re: Update on Burnt Valve
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Janicholson on October 30, 2006 at 17:08:21 from (66.173.50.21):
In Reply to: Update on Burnt Valve posted by Steve200460 on October 30, 2006 at 15:33:12:
A cylinderleak down test is a good analytical next step. One closes the valves by having the cylinder on tdc compression nad locking it in that location with a combination of being in high gear, locked brakes, and possibly a wrench on the front pulley nut to hold it from turning. Then apply air pressure to the cylinder with a used sparkplug with a fitting brazed into the place where the porcelin was located. This air pressure (100psi or so) will leak out of the same spot that the compression leaks during running. One listens to the intake at the carb (with air cleaner removed), to the exhaust in the muffler, and in the oil fill hole. The hissing will reveal the location. I believe an engine that is not using major oil (smoking blue grey) and seems tight will run well with out replacing the rings etc. If it does, all you have lost is some time and a head gasket, If it doesn't you have saved a bunch of money and time. My two cents, JimN
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|