Farmall & IHC Tractors Discussion Board |
Re: C charging problems revisted
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by John T on October 28, 2006 at 20:16:03 from (66.244.90.5):
In Reply to: C charging problems revisted posted by Tim Mattson on October 28, 2006 at 17:53:28:
Tim, It sounds like your wiring is correct, the wire on the 3rd brush should have been the leading Field winding which would wire up to the incoming ARM post if it were only a 2 brush genny which is the same basic place as there on the non grounded brush....... If it charges ONLY with the gennys Field post dead grounded but NOT otherwise, the problems either the VR or the VR isnt well grounded or the wires bad from FLD on the VR to the gennys Field post. I would try n run a good ground to the VR"s case n see if that fixes the problem cuz if its not well grounded (usually to gennys case) it cant ground the Field as it is supposed to. Many VR"s will work at EITHER Pos or Neg ground so is yours compatible with your ground?? If a VR were hooked up to a genny that wanst polarized correct and the tractor started it could damage the VR, have you Polarized lately and/or changed the battery ground??? John T
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|