Re: Update on 1950 Cub charging

Posted by John T on October 25, 2006 at 06:53:07 from (66.244.90.5):

In Reply to: Update on 1950 Cub charging posted by glen kaiser on October 25, 2006 at 05:40:47:

Glen,

I totally agree with Bob M...... YES when motor testing a genny it should run somewhat faster with the Field post disconnected from ground, and if not I also suspect theres a field winding problem in the genny. If it motors fairly fast n smooth n even that means the armature and brushes are in somewhat "decent" shape at least.

If the armature and/or brushes were removed so the armature n ground circuit is out of the equation, you could take an ohmmeter and insure the two field windings are continuous from the ARM post to the FIELD post (if a 2 brush genny) which would be in the vicinity of a few (maybe 2 to under 10, depends on if 6 or 12 volt) ohms and then insure neither field winding is shorted to the case cuz there should be an open circuit (very high ohms) from either genny post to its case UNLESS one of the field windings is shorted to case.

Another place where field windings can go bad is where the two are spliced together cuz the splice can get broke or else one of the windings get shorted to the case.

Remember with the tractor running if the field is dead grounded and then the cutout relay portion of a VR or stand alone 2 wire Cutout Relay is by pass jumped (BAT and GEN/ARM terminals connected together) the VR is out of the equation, so if still no charge and all else is okay its a Genny NOT any VR problem.

That buzz or whine could be brushes like Bob was talking about which can happen if the commutator gets rough and/or the copper is worn down and the insulators arent undercut causing brush bounce or maybe a bushing is dry or a bearing is going bad?????

Bob M,

NO apologies due me, as far as multiple answers I think it helps the questioner to get more then one opinion as each may explain the issue slightly different and the more the merrier, after all were here to help by providign alllllll the info we can muster up. I consider you as the IHC ELECTRICAL GURU especially since I havent used Farmalls in years but Ive still "been around the electrical block" a few times and stand knee deep enough in theory to help on electrical questions best I can so its good we can help "keep each other honest" time to time lol.

Yall take care now

John T (NOT an IHC man but love lectricity)

Replies:

• Re: Update on 1950 Cub charging glen kaiser 16:11:42 10/25/06 (1)
  • Re: Update on 1950 Cub charging glen kaiser 16:14:55 10/25/06 (0)

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]