Farmall & IHC Tractors Discussion Board |
Re: super a rebuild advice
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Dave BN on October 23, 2006 at 12:46:00 from (216.120.174.99):
In Reply to: super a rebuild advice posted by werowance on October 23, 2006 at 12:06:59:
Drop the oil pan. Clean the oil pump screen and take the bottom plate off of the oil pump. This plate will be worn from the gears running against it. Have this plate machined smooth. Replace the pressure regulator spring and plunger. Chech the gears for wear(probably will be OK). Put back together with new, very thin gasket and you will have rebuilt your oil pump. Reinstall oil pan with new gasket also. This will most likely bring your oil pressure up to an acceptable level. If your engine doesn't knock or smoke you may be all set. Good Luck. Dave.
Replies:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|